DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (2024)

September 19, 2016January 7, 2018 / 9 comments

Get ready for Taco Tuesday by making your own modern taco serving platter! Learn how to make easy baked crispy shrimp tacos that the whole family will love.

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (1)

When you can’t decide what’s for dinner onething I think just about everyone can always agree on is tacos. Am I right? Today I’m sharing a delicious crispy shrimp taco recipe complete with a super simple DIY taco stand. Because the only thing that can make any taco night better is a stylishDIY projectand a delicious and easy recipe!

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (2)

What makes this taco recipe easy peezy is that all the crunch comes from coating the shrimp in Harvest Snaps. You might remember that I shared a dip recipea while back that featured these crunchysnacks. These healthy low carb crispsalso double as the perfect coating for shrimp.Just crush them up in the food processor or by hand by placing them in a zip top bag and giving them a go with a meat mallet. Thisresults ininstant “bread crumbs” that actually aren’t bread crumbs at all butcrisps made frombeans!This recipe uses the Black Bean Mango Chile Lime snaps as the coating so you don’t need to useany flour or a deep fryer. They have a sweet chipotle flavors and go perfectly with all your favorite taco toppings.

Watch the video below tosee just how easy this recipe is to make andcontinue reading to learn how to make your own gold and woodtaco stand.

Makes 6 tacos

Ingredients

1 pound peeled and deveined shrimp, with tails removed
1 bagBlack Bean Mango Chile Lime Harvest Snaps
2cupsshredded red cabbage
2tbsp lime juice
1 tbspolive oil
½ tsp coarse salt
4 tablespoons unsalted butter
jalapeño slices,to taste
radish slices
queso fresco
sour cream
lime zest
cilantro

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (3)

Shrimp TacoDirections

  1. In a small bowl combine the red cabbage, lime juice, olive oil and salt. Stir until the mixture is evenly distributed and refrigerate until readytoserve.
  2. Pulse1 bagBlack Bean Mango Chile Lime Harvest Snapsina food processor until it resembles bread crumbs.You can also crush them by transferringthe snaps into a gallon zip top bag and gently breaking them with a meat mallet or hammer.
  3. Rinse and dry shrimp. Coat all the shrimp in the snaps crumbs.
  4. Heat a large skillet over medium high heat. Add 4 tbsp unsalted butter and melt. Add the shrimp in a single layer (you mayneed to cook them in two batches if using a smaller skillet) and cook 2 minutes per side or until pink throughout. Remove from skilled and drain on a paper towel.
  5. Place 6 warm tortillas on the taco stand. Add shrimp (about 3-4 per taco) and top with the lime pickled cabbage. Add all your other favorite toppings such as fresh jalapeño slices, thinly sliced radishes, queso fresco, sour cream, cilantro and lime zest. Enjoy immediately!

If you’re not a big fan of shrimp, you could alsocoat chicken or fish with the crushed up Harvest Snaps. Just be sure the meat or seafood is cooked all the way through before serving.

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (4)

Supplies

wood servingboard
7 brass drawer pullswith holes 3¾” apart
E6000 glue
rulers/tape measure
pencil

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (5)

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (6)

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (7)

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (8)

Taco Stand Directions

  1. Measure the length of the wood board, find the center, and mark it lightly with a pencil about an 1¼” from the side. Repeat the same thing on the opposite side of the board.
  2. Apply a tiny amount of glue toboth ends of a drawer pull. Carefullyplace it on the board and center it between the two marks. Hold itfirmly into place for a few seconds for the glue to begin to set.
  3. Lightly mark the left and right sides for the placement of theoutside drawer pulls about 1″ from the short end and an 1¼” from the long side. Glue the outside drawer pulls into place.
  4. Using rulers as a guide, glue theremaining 4 drawer pulls into place. Measuring isn’t necessary for these and you can usethe center and outside drawer pulls as reference and just eye it.
  5. Allow the glue to dry for 24 hours before using.After using your board on a taco night, wipe it clean with a damp cloth.

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (9)

The glue takes a good 24 hours to set and up to 72 hours to fully cure. If you impatiently keep checking it while it dries like I did, don’t stress that it’s not adhering. This type of glue needs time to do it’s thing. Andsince the brasshardware is glued onto the wood board, I don’t recommendcarrying it by handles.

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (10)

Shop for snacks and supplies

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (11)


DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (12)

DIY Taco Stand and Crispy Shrimp Taco Recipe - Sarah Hearts (2024)

References

Top Articles
Latest Posts
Article information

Author: Roderick King

Last Updated:

Views: 5521

Rating: 4 / 5 (51 voted)

Reviews: 82% of readers found this page helpful

Author information

Name: Roderick King

Birthday: 1997-10-09

Address: 3782 Madge Knoll, East Dudley, MA 63913

Phone: +2521695290067

Job: Customer Sales Coordinator

Hobby: Gunsmithing, Embroidery, Parkour, Kitesurfing, Rock climbing, Sand art, Beekeeping

Introduction: My name is Roderick King, I am a cute, splendid, excited, perfect, gentle, funny, vivacious person who loves writing and wants to share my knowledge and understanding with you.